Figure 2‐4: mSATA SSD installation
Step 3: Replace the HDD bracket, cover and screws.
2.5 Memory installation
This section outlines the installation of the memory in the TPC6000‐A2152‐T. To install the
memory, please follow the steps below:
Step 1: Flip over this device and you can see its back.
Step 2: Unfasten the 4 silver retention screws on the left and right side. (Figure 2‐5)
Step 4: Lift the cover to remove.
Step 5: Locate the memory bracket.
Step 6: Plug the DDR3L memory bar into the DDR3L slot in the angle of 45 degrees then push
lightly down till the two metal clips vise the memory bar with a sound "pa", and
done safety.
Step 7: Plant the cover on back of the device.
2.6 Mounting system
Warning:
The panel PC is very heavy, two or more people should mount the panel PC. Dropping or
bumping the panel PC during installation can cause serious or irreparable damage to the
panel PC
The following installation options are available:
TPC6000‐A2152 User Manual
19