Hard Drive Installation; Ssd Installation By Using Msata - American Megatrends TPC6000-A2152 User Manual

2.3 Hard drive installation
This section outlines the installation of the hard drive in the TPC6000‐A2152‐T. To install the
hard drive, please follow the steps below:
Step 1: Flip over this device and you can see its back.
Step 2: Unfasten the 4 silver retention screws on the left and right side. (Figure 2‐1)
Step 3: Lift the cover to remove.
Step 4: Locate the HDD bracket.
Step 5: Insert the SATA connector at the end of the HDD into the bracket to connect the
motherboard SATA connector to the hard drive SATA connector as shown in the
figure below.
Step 6: Plant the screw on the HDD bracket.
Step 7: Replace the covers and screws.
2.4 SSD installation by using mSATA
The installation for a SSD is described in this section.
Step 1: Remove the HDD bracket just like mentioned on the "Hard drive installation steps".
Step 2: Insert the mSATA SSD into the mSATA slot as shown in the Figure 2‐4 below:
TPC6000‐A2152 User Manual
18