Warning:
When installing the TPC6000‐A2152‐T, make sure to:
Turn the power off: chance of electrocution. Turn off the monitor and unplug it from
the power supply.
Only let certified engineer change the hardware settings: Incorrect settings can cause
irreparable damage to the product.
Install the monitor with assistance: The product is very heavy and maybe damage by
drops and bumps. Two or more people should install the panel PC.
Take anti‐static precautions: Electrostatic discharge can destroy electrical components
and injure the user. Users must ground themselves using an anti‐static wristband or
similar device.
The installation steps below should be followed in order:
Step 1: Unpack the flat panel PC;
Step 2: Check all the required parts are included;
Step 3: Install the hard drive;
Step 4: Install the compact flash card;
Step 5: Mount the flat panel PC;
Step 6: Connect peripheral devices to the bottom panel of the flat panel PC;
Step 7: Connect the power cable;
Step 8: configure the system;
2.1 Unpack the flat panel PC
Unpack the flat panel PC, follow the step below:
Step 1: Carefully cut the tape stealing the outside box. Only cut deep enough to break the
tape.
Step 2: Open the outside box.
Step 3: Carefully cut the tape stealing the inside box. Only cut deep enough to break the
tape.
Step 4: Open the inside box.
Step 5: Lift the monitor out the box.
Step 6: Remove the peripheral box from the main box.
TPC6000‐A2152 User Manual
16