Parameter Level; Entering Parameters; Configuration Level; Changing The Configuration Code - Siemens RWF40.000A97 User Manual

6.3 Parameter level

6.3.1 Entering parameters

6.4 Configuration level

6.4.1 Changing the configuration code

HVAC Products
The parameters involved in adapting the controller to the controlled system are set here
after the system has been started up.
Within the level, you can proceed to the next parameter by pressing
F
The display of the individual parameters depends on the type of controller.
Entry and alteration of the parameters is made through continuous alteration of the
value. The longer you keep the button pressed, the faster the rate of change.
‫ ٭‬Increase value by pressing
‫ ٭‬Decrease value by pressing
‫ ٭‬Accept entry by pressing
or
‫ ٭‬Cancel entry by pressing
F
After 2 seconds, the set value will automatically be accepted. The value can
only change within the permissible value range.
ð
Chapter 7 «Parameter settings»
The settings made here are those required for commissioning a specific installation and,
therefore, need hardly ever be altered later on (acquisition of measured value or type of
controller).
Within the level, you can advance to the next parameter by pressing
‫ ٭‬Select position by pressing
‫ ٭‬Alter value by pressing
‫ ٭‬Accept code by pressing
or
‫ ٭‬Cancel entry by pressing
ð
Chapter 8 «Configuration»
CC1B7865en
=
>
PGM
EXIT
>
(position flashes!)
=
PGM
EXIT
05.12.2002
6. Operation
PGM
.
PGM
.
35/57