Brother HL-L2395DW Online User's Manual page 599

Level 1 Level 2
Wi-Fi Device Info.
Direct
Status Info.
I/F Enable
Network -
Reset
For wireless network models
Level 1 Level 2
WLAN TCP/IP
Setup Wizard
WLAN Assistant -
WPS
WPS w/PIN Code -
Level 3 Level 4
Device -
Name
SSID -
IP Address -
Status -
Signal
-
Channel -
Speed
-
- -
- -
Level 3 Level 4
Boot -
Method
IP Address -
Subnet -
Mask
Gateway -
Node Name -
WINS -
Config
WINS Primary
Server
Secondary Specify the IP address of the secondary WINS
DNS Server Primary
Secondary Specify the IP address of the secondary DNS
APIPA -
IPv6 -
- -
-
- -
-
Descriptions
View your machine's device name.
View the Group Owner's SSID.
When the machine is not connected, the LCD
displays Not Connected.
View your machine's current IP Address.
View the current Wi-Fi Direct network status.
View the current Wi-Fi Direct network signal
strength.
When your machine acts as Group Owner, the
LCD always indicates a strong signal.
View the current Wi-Fi Direct network channel.
View the current Wi-Fi Direct network speed.
Turn the Wi-Fi Direct connection on or off.
Restore all network settings back to the factory
settings.
Descriptions
Select the Boot method that best suits your needs.
Enter the IP address.
Enter the Subnet mask.
Enter the Gateway address.
Enter the Node name.
(Up to 32 characters)
Select the WINS configuration mode.
Specify the IP address of the primary WINS
server.
server.
Specify the IP address of the primary DNS server.
server.
Set the machine to allocate the IP address from
the link-local address range automatically.
Turn the IPv6 protocol on or off. For more detailed
information, go to your model's FAQs &
Troubleshooting page on the Brother Solutions
Center at support.brother.com.
Configure your wireless network settings manually.
Configure your wireless network settings using the
Brother installation disc.
Configure your wireless network settings using the
one-button push method.
Configure your wireless network settings using
WPS with a PIN.
592