Milkotester Master Pro Operating Instructions Manual page 28

Use the ↑↓ (up and down) arrows and press ENTER to select the
type of milk. The following text will appear on the display:
Use the ↑↓ (up and down) arrows and press ENTER to select a
parameter. Then the cursor will mark the place to enter a known value.
Use the ↑↓ (up and down) arrows to set the desired figure and press
ENTER to confirm. Then the cursor goes to the figure to the right. Use the
same procedure to enter the second and third figure. After confirmation of
the last figure the cursor goes to the next parameter for entering new
values (mind that there are 2 (two) pages of components thus scroll up
and down).
By confirming the last figure of the last parameter the following text
appears on the display:
Cow milk
Sheep milk
UHT milk
Backup Calibration
---------------------------
Restore Calibration
Sensor RESET
Set High sample
FAT=x.xx
SNF=x.xx
DEN=x.xx
Set High sample
PRO=x.xx
LAC=x.xx
SAL=x.xx
Set Low sample
FAT=x.xx
SNF=x.xx
DEN=x.xx
28
Ultrasonic milk analyzers
Operating Instructions Master Pro
Milkotester Ltd