SeeMeCNC Rostock MAX v2 User Manual page 5

Rostock MAX v2 RTP User Guide
Step 5 — Software Install, Setup, and How to Operate your new 3D Printer
Download: Rostock Max v2 User Manual

Familiarize yourself with the READ ME FIRST section on page 2

Perform the driver installation as instructed on pages 5-6

YOU DO NOT NEED TO PERFORM THE STEPS ON PAGES 7-12. THE PRINTER'S FIRMWARE

IS ALREADY LOADED ONTO THE RAMBO BOARD.
Familiarize yourself with the LCD and Front Panel Controls on pages 13-15

Install and configure MatterControl as directed on pages 17-22

YOU DO NOT NEED TO PERFORM THE INITIAL FUNCTION TESTS ON PAGES 23-35. YOUR

PRINTER IS ALREADY FULLY CONFIGURED AND CALIBRATED
Get some practice printing! Pages 36-42 in the manual will teach you how to print a fan shroud on

your new printer. This part is already installed on your printer, however this will be good practice
for learning how to operate the software and printer.
© 2017 seemecnc.dozuki.com Page 5 of 7