Step 1 — Unpackaging And Setup - SeeMeCNC Rostock MAX v2 User Manual
Hide thumbs
Also See for Rostock MAX v2:
- Assembly manual (281 pages) ,
- User manual (128 pages) ,
- Assembly manual (314 pages)
Table of Contents
Advertisement
Rostock MAX v2 RTP User Guide
Step 1 — Unpackaging and Setup
Your machine was fully assembled, calibrated and printed successfully before it left our factory.
We have done some things to make sure the machine does not get damaged while shipping the
printer. Please complete the following steps
Carefully remove all shrink wrap from the printer. Be careful not to cut the machine if you are using
a knife.
The arms have been inverted to prevent the hot end nozzle from striking the glass print surface
during shipping. To invert the arms from shipping position to printing position, place your hand on
ONE of the carriages and slowly move this carriage upward toward the top of the printer.
Next select one of the two remaining carriages and repeat.
Do the same operation with the final carriage.
Remove the BLUE calibration print from the print bed. (we leave that on there for you to see that
your printer has been calibrated and printed on and is ready for printing)
© 2017
seemecnc.dozuki.com
Page 2 of 7
Advertisement
Table of Contents
Need help?
Do you have a question about the Rostock MAX v2 and is the answer not in the manual?
Questions and answers