Configuration In Windows Nt4 - Keithley 2701 Instruction Manual

3-12 Configuring TCP/IP addresses

Configuration in Windows NT4

Refer to
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 3-5
Windows NT4 Ethernet card settings
Figure 3-5.
Click on the Windows Start button.
Select Settings, then Control Panel.
Open the folder named Network.
Select the Protocols Tab.
If there is no entry for TCP/IP, click Add, then select TCP/IP and follow on-screen
directions.
After TCP/IP protocol installation, click on Properties. On the IP Address tab, select the
proper adapter (NIC), then select the method of obtaining your IP address. For an iso-
lated network, click on "Specify An IP Address".
Complete the IP Address and Subnet Mask according to your network configuration
(Figure 3-5).
The Default Gateway and the DNS settings could be needed when connecting to a cor-
porate network. For an isolated network, these settings are not used.
Follow the instructions on the screen and reboot as necessary.
Model 2701 Instrument Networking Instruction Manual