Advantech MIO-2360 User Manual page 21

2.2.2.4 GPIO (General Purpose Input Output) (CN7)
The board supports 8-bit GPIO (5 V tolerance) through GPIO pin header. The 8 digi-
tal inputs and outputs can be programmed to read or control devices, with each input
or output defined.
2.2.2.5 VGA/ HDMI/ LVDS Interface Connections (CN16/CN17/CN15)
The MIO-2360's display interface support either VGA or HDMI on rear IO and is
capable of driving a wide range of flat panel displays, including passive LCD and
active LCD displays.The board has three kinds of connector types to support these
displays: one is on rear IO support either standard CRT VGA monitors or high defini-
tion HDMI display and one for LVDS type LCD panels.
CRT display connector (CN16)
The CRT display 15pins connector is a rear I/O connector on coastline used for con-
ventional CRT displays. Resolution: up to 3840 x 2160 at 30Hz.
HDMI display connector (CN17)
MIO-2360 also support HDMI display output, meet HDMI1.4a specification. Resolu-
tion: up to 1920 x 1200 at 60Hz.
LVDS LCD panel connector (CN15)
The board supports single channel 18/24-bit LVDS LCD panel displays via 14*1pin
wafer box. Resolution: up to 1400 x 900.
2.2.2.6 Front Panel Connector(CN22)
MIO-2360 integrates below functions as front panel 6pin connector.
Power button
Supports power on/off button in ATX mode.
Reset
If you install a reset switch, it should be an open single pole switch. Momentarily
pressing the switch will activate a reset.
Power LED
Power LED indicator would light when power is on.
HDD LED
HDD LED indicator for hard disk access is an active low signal
2.2.2.7 SATA Connector (CN11)
MIO-2360 features one high performance Serial ATA interfaces. Data transfer rates
up to 600 MB/s enabling very fast data and file transfer, and independent DMA oper-
ation on two ports.
2.2.2.8 mSATA Connector (CN12)
MIO-2360 provides a full size mini-PCIe socket which integrates SATAIII signals,
supports mSATA interface modules.
2.2.2.9 Mini PCIe Connector (CN16)
MIO-2360 supports a full size mini PCIe slot. PCI Express Mini Card (also known as
Mini PCI Express, Mini PCIe, and Mini PCI-E) is a replacement for the Mini PCI form
factor based on PCI Express. It is developed by the PCI-SIG. The host device sup-
ports both PCI Express and USB 2.0 connectivity.
2.2.2.10 USB Connectors (CN19 and CN20)
The board provides four USB (Universal Serial Bus) ports, two are rear I/O on coast-
line (CN20); and the other two are internal USB ports (CN19). The rear I/O USB port
support two USB 3.0 ports. The USB 3.0 ports comply with USB specification Rev.
MIO-2360 User Manual 10