Table of Contents
Advertisement
CHAPTER 9: USERS
9.2.1 ADD USER
To create a user, click on the +User button at the top of the page and this opens up the new user wizard. The initial page of this
wizard is shown in Figure 42.
The administrator can use a template to follow a common set of properties for a user as described in the next section. The
definitions of the properties of a user are:
Š User Name: This is a unique name that uses 1–32 characters. The username can be any valid username for a Microsoft O/S. This
Š
means the username cannot contain " "/ \ [ ] : ; | = , + * ? < > `'.
Š Password: This field can be a minimum of 0 characters (i.e. blank) and a maximum of 32 characters. The password can be any valid
Š
password for a Microsoft O/S. This means the password cannot contain " "/ \ [ ] : ; | = , + * ? < > `'
Š User Privilege: This field defines the type of user the new user will be: Administrator, General User or Power User.
Š
Š Auto-Connect: This enable/disable whether the InvisaPC Receiver attempts to connect immediately to the selected connection
Š
after a logon by this user. This automatic connection only occurs after a logon. If a user exits the connection, the connection tab is
displayed to the user for selection of a connection.
Once the new user fields have been filled out, you must click the Save button to create the new user. Clicking the Save button
causes the validation of the new username, checking that it is unique and that the two password entries match. If this validation
fails, a pop-up window displays the reason for the failure, and the new user is not created. After dismissing the pop-up window, the
user can fix the error and click Save again.
48
FIGURE 42. NEW USER WIZARD
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
Advertisement
Table of Contents
