Show/Hide Bookmarks
Safety information
2.3 Residual hazards
Operator's safety
Protection of
devices
Overspeeds
2-4
820XBA1097
After mains disconnections, the power terminals U, V, W and + U
least three minutes.
-
Before working on the controller, check that no voltage is applied to the power terminals.
Cyclic connection and disconnection of the controller supply voltage at L1, L2, L3 or + U
-U
may overload the internal input current load:
G
-
Allow at least 3 minutes between disconnection and reconnection.
Drive systems can reach dangerous overspeeds (e. g. setting of inappropriately high field
frequencies):
-
The controllers do not offer any protection against these operating conditions. Use
additional components for this.
, -U
remain live for at
G
G
,
G