Bandwidth Manager Class Configuration - ZyXEL Communications ZyWall 5 Series User Manual

Table 139 ADVANCED > BW MGMT > Class Setup (continued)
LABEL
Service
Destination IP
Address
Destination Port
Source IP
Address
Source Port
Protocol ID
Move

24.12.1 Bandwidth Manager Class Configuration

Configure a bandwidth management class in the Class Setup screen. You must use the
Summary screen to enable bandwidth management on an interface before you can configure
classes for that interface.
Click ADVANCED > BW MGMT > Class Setup > Add Sub-Class to open the following
screen. Use this screen to add a child class.
Chapter 24 Bandwidth Management
DESCRIPTION
This is the service that this bandwidth management class is configured to manage.
This is the destination IP address for connections to which this bandwidth
management class applies.
This is the destination port for connections to which this bandwidth management
class applies.
This is the source IP address for connections to which this bandwidth management
class applies.
This is the source port for connections to which this bandwidth management class
applies.
This is the protocol ID (service type) number for connections to which this bandwidth
management class applies. For example: 1 for ICMP, 6 for TCP or 17 for UDP.
Type a class's index number and the number for where you want to put that class.
Click Move to move the class to the number that you typed. The ordering of your
classes is important as they are applied in order of their numbering.
ZyWALL 5/35/70 Series User's Guide
433