Figure 84 Network > Wlan; Table 50 Network > Wlan - ZyXEL Communications ZyWall 5 Series User Manual

ZyWALL 5/35/70 Series User's Guide
Click NETWORK, > WLAN to open the WLAN screen to configure the IP address for
ZyWALL's WLAN interface, other TCP/IP and DHCP settings.
Figure 84 NETWORK > WLAN
The following table describes the labels in this screen.
Table 50 NETWORK > WLAN
LABEL
WLAN TCP/IP
IP Address
IP Subnet Mask
RIP Direction
190
DESCRIPTION
Type the IP address of your ZyWALL's WLAN interface in dotted decimal notation.
Alternatively, click the right mouse button to copy and/or paste the IP address.
Note: Make sure the IP addresses of the LAN, WAN, WLAN and
DMZ are on separate subnets.
The subnet mask specifies the network number portion of an IP address. Your
ZyWALL automatically calculates the subnet mask based on the IP address that
you assign. Unless you are implementing subnetting, use the subnet mask
computed by the ZyWALL.
RIP (Routing Information Protocol, RFC1058 and RFC 1389) allows a router to
exchange routing information with other routers. The RIP Direction field controls
the sending and receiving of RIP packets. Select the RIP direction from Both/In
Only/Out Only/None. When set to Both or Out Only, the ZyWALL will broadcast
its routing table periodically. When set to Both or In Only, it will incorporate the RIP
information that it receives; when set to None, it will not send any RIP packets and
will ignore any RIP packets received. Both is the default.
Chapter 10 Wireless LAN