ZKTeco X7 User Manual
Access control system
Hide thumbs
Also See for X7:
- User manual (14 pages) ,
- User manual (15 pages) ,
- System user manual (16 pages)
Related Manuals for ZKTeco X7
Summary of Contents for ZKTeco X7
- Page 1 Version: 1.2.1...
-
Page 2: Equipment Installation
1. Equipment Installation (1) Remove the screw on (2) Take away the back cover. (3) Fix the back cover on the the bottom of device. wall according to the mounting paper. (4) Fix the device to the (5) Fix the screw. Tamper Alarm Button back cover. -
Page 3: Lock Connection
3. Lock Connection Warning: No operation when power on! (1) The system supports NO LOCK and NC LOCK. The NO LOCK (normally open at power on) is connected with NO terminal, and the NC LOCK is connected with NC terminal. (2) To prevent the generation of self-inductance EMF which would affect the system, when the electrical lock is linked to the Access Control System, it is required to connect one FR107 diode (equipped in the package, do not reverse the polarities) in... -
Page 4: Connected With Other Devices
4. Connected with Other Devices Only devices with an alarm ≤ DC 12V can be connected. 5. Connect with Power Input DC 12V, 500mA (50mA in idle status) Positive is connected with +12V, negative is connected with GND (do not reverse the polarities). - Page 5 Βιομετρικός Ελεγκτής SA-X6 Ο βιομετρικός ελεγκτής SA-X6 υποστηρίζει κλειδαριές NO Lock & NC Lock. Προσοχή: θα πρέπει παράλληλα με το φορτίο (κλειδαριά) να συνδεθεί μία δίοδος FR107, όπως φαίνεται στο σχήμα για προστασία από EMF. User management Administration Operations For the security the data, admin password is needed to operate the machine. ...
- Page 6 Remark: when we enrol users, we need to input staff's ID number such as : 001 and then press finger or punch cards... 2:How to delete all users? Press * + # - Press administrator finger -- Press 9 + # ---- Press * to exit. 3:Setup verify mode (factory FP/PW/RF) Press * + # -- Press Administrator finger - Press 5---input verify mode number # and press * exit.