Solving Problems; Checking The Printer Status; Checking Messages On The Lcd Screen - Epson ET-3750 series User Manual

User's Guide

Solving Problems

Checking the Printer Status

Checking Messages on the LCD Screen

If an error message is displayed on the LCD screen, follow the on-screen instructions or the solutions below to
solve the problem.
Error Messages
Printer Error
Turn on the printer again. See your
documentation for more details.
Paper out in XX.
The printer's ink pad is nearing the end of its
service life. Contact Epson Support.
The printer's ink pad is at the end of its service
life. Please contact Epson Support.
Paper Configuration is disabled. Some features
may not be available. For details, see your
documentation.
The combination of the IP address and the
subnet mask is invalid. See your documentation
for more details.
To use cloud services, update the root certificate
from the Epson Web Config utility.
Check that the printer driver is installed on the
computer and that the port settings for the
printer are correct.
Check that the printer driver is installed on the
computer and that the USB port settings for the
printer are correct.
Recovery Mode
* In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the printer is designed to stop printing when the pad has reached its limit. Whether and how often
Solving Problems
Solutions
Remove any paper or protective material in the printer. If the error
message is still displayed, contact Epson support.
Load paper, and then insert the paper cassette all the way.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part. The message will be displayed
until the ink pad is replaced.
Select OK to resume printing.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part.
If Paper Setup Auto Display is disabled, you cannot use AirPrint.
Enter the correct IP address or default gateway. Contact the person who
setup the network for assistance.
Run Web Config, and then update the root certificate.
Make sure the printer port is selected correctly in Property > Port from
the Printer menu as follows.
Select "USBXXX" for a USB connection, or "EpsonNet Print Port" for a
network connection.
The printer has started in recovery mode because the firmware update
failed. Follow the steps below to try to update the firmware again.
1. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the firmware over a network
connection.)
2. Visit your local Epson website for further instructions.
142