Making Wi-Fi Settings By Pin Code Setup (Wps) - Epson ET-3750 series User Manual

User's Guide
7. Close the screen.
The screen automatically closes after a specific length of time.
Note:
If connection fails, restart the access point, move it closer to the printer, and try again. If it still does not work, print a
network connection report and check the solution.
8. Close the network connection settings screen.
Related Information
"Basic Operations" on page 17
&
"Checking the Network Connection Status" on page 31
&
"When You Cannot Make Network Settings" on page 150
&

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can automatically connect to an access point by using a PIN code. You can use this method to set up if an
access point is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the access point.
1. Select on the home screen.
To select an item, move the focus to the item using the
2. Select Wi-Fi (Recommended).
If the printer has already been connected by Ethernet, select Router.
3. Press the OK button.
If the network connection is already set up, the connection details are displayed. Select Change Settings to
change the settings.
If the printer has already been connected by Ethernet, select Change to Wi-Fi connection., and then select Yes
after checking the message.
4. Select Others > PIN Code Setup (WPS).
Network Settings
u d l r
buttons, and then press the OK button.
27