Selecting Dhw Heating Only Once - Viessmann Vitotronic 100 HC1 User's Manual And Operating Instructions

Selecting DHW Heating Only Once

28
The following function enables you to heat DHW once, without permanently altering
your settings. For this, select "Party mode" g.
Preconditions:
Not in "Standby mode" 9 and not in the "Holiday program" j
The DHW temperature must be below the set value (see page 24)
1. / / for the required heating
3
circuit.
12. g for "Party mode".
Vitotronic 100, HC1
It is possible to simultaneously reset all changed values for the heating circuit to
their factory default settings.
For this, press D.
Vitotronic 300-K, MW2S
It is possible to simultaneously reset all changed values for the heating circuit to
their factory default settings.
For this, press D.
1. / / for the required heating
3
circuit.
3. to confirm; DHW heating
begins.
4. After approximately 10 seconds,
press g again; the key illumination
extinguishes.
2. D for "factory default setting".
3. to confirm.