Grounding the Optional GPS Arrestor
The way to connect the ground cable with the GPS arrestor is as follows.
Table 23. Grounding the GPS Arrestor (MGB GPS Arrestor)
Classification
Installation section
Cable
Heat shrink tube
(spec/color/length)
Pressure terminal
Fastener
Recommended torque
value (kgf.cm)
Working tools
Pressure Terminal for Grounding
As for the pressure terminal or the cable, the UL listed products or equivalent
should be used.
For example:
Verizon 4G LTE Network Extender 2 User Guide v1.1
Copyright © 2017, All Rights Reserved.
Description
MGB ground terminal of arrestor
AWG8, F-GV 6 mm2 × 1C/1 EA
Ф 0.4 in. (10 mm)/Green/1.97 in. (50 mm)
MGB
Arrestor
MGB
Arrestor
M5 hex. bolt
Cable cutter, wire stripper, compressor, heating gun, torque driver (+), torque wrench,
and nipper
Manufacturer: JEONO Electric
GPS Arrestor: 6 mm2 Pressure Terminal (JOR 6-5)
Appendix A Outdoor GPS Antenna Installation
Checking the MGB specifications per site and preparing
fasteners
6 mm2, ring type, hole dia.: 0.21 in. (5.3 mm)
Checking the MGB specifications per site and preparing
fasteners
M5 hex. bolt/1 EA
M5 spring washer/1 EA
M5 plane washer/1 EA
(attached at the GPS arrestor)
1.45~2.17 ft.lb. (20 ~ 30 kgf.cm)
68