Download Print this page

Advertisement

User Menual
Model : SCS-26UC4
UbiCell User Guide _

Advertisement

   Also See for Samsung UbiCell

   Related Manuals for Samsung UbiCell

   Summary of Contents for Samsung UbiCell

  • Page 1

    User Menual Model : SCS-26UC4 UbiCell User Guide _...

  • Page 2

    This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. _ © SAMSUNG Electronics Co., Ltd.

  • Page 3: Safety Concerns

    Indication for prohibiting an action for a avoid a service failure or damage to the product. system. Note Instruction Indicates additional information as a Indication for commanding a reference. specifically required action. UbiCell User Guide _...

  • Page 4: Warning

    Do not connect many Pull out the power plug tightly and fully into the UbiCell or power plug devices to a single when the UbiCell is not outlet. with wet hands. outlet. used for a long time or bad weather condition.

  • Page 5

    UbiCell or fire. Failure to do so Moisture in the Failure to do so may cause fire or UbiCell can cause may cause fire or electric shock. a fire and electric electric shock. shocks. UbiCell User Guide _...

  • Page 6: Caution

    UbiCell, and your purchased or call the detergent. lifetime. UbiCell may not work Service Center. Failure to do so may properly. cause the damage to the product. _ © SAMSUNG Electronics Co., Ltd.

  • Page 7

    Do not install the product on unstable the UbiCell. UbiCell. UbiCell near the support and always be products which release The UbiCell can be Doing so may cause in an upright position. electromagnetic waves damaged. product malfunction such as microwaves,...

  • Page 8

    Installation/Maintenance Clean the UbiCell with a Check the maximum The UbiCell must be Please use a refined soft and dry cloth when length of the cable placed more than 50 cm accessory and a cleaning. and install it near the...

  • Page 9

    When detaching the GPS good ventilation. Install the should be plugged before antenna from the UbiCell to UbiCell at a distance of more plugging a DC power cable. receive superior GPS signal, than 30 cm from the walls or connect extension cable to GPS Not doing so may cause product other products.

  • Page 10

    Installation/Maintenance GPS antenna detached from the If the UbiCell does not work for a The UbiCell should be registered UbiCell always should be located long time, check the state of LED first. indoors. and call customer service. Your UbiCell will not be able to...

  • Page 11: Table Of Contents

    삭제됨: 11 Congratulations!....................13 삭제됨: 12 About This Guide ....................13 What’s in the box ....................14 삭제됨: 13 Names and Functions of each part...............15 LED.................................15 Connector...............................16 삭제됨: 13 Registering your UbiCell ..................19 삭제됨: 14 OVERVIEW 삭제됨: 17 삭제됨: UbiCell User Guide _...

  • Page 12

    삭제됨: INSTALLING YOUR UBICELL 삭제됨: TROUBLESHOOTING 삭제됨: ANNEX A Product Specifications ..................27 삭제됨: 25 _ © SAMSUNG Electronics Co., Ltd.

  • Page 13: Preparation

    About This Guide This user guide provides instructions for the use of the UbiCell. Please take the time to make sure of this guide to become familiar with the operation of your UbiCell and the benefits this new UbiCell can provide.

  • Page 14: What's In The Box

    After purchasing this product, check if the items below are all included in the package. If any item is missing or damaged, contact your dealer: Power Supply and Cord UbiCell Ethernet Cable User Guide _ © SAMSUNG Electronics Co., Ltd.

  • Page 15: Names And Functions Of Each Part

    Names and Functions of each part The UbiCell is very simple. On one end it has connectors for power and LAN. On the other end the UbiCell has four LED indicators to let you know its status. Name Description When powering on the UbiCell, it turns blue.

  • Page 16: Connector

    Connector Name Description Antenna Provides omni-directional transmission and reception of signals between the UbiCell and communicating mobile station. Connects the power cable. Connects the Ethernet cable. _ © SAMSUNG Electronics Co., Ltd.

  • Page 17

    The GPS antenna detached from the UbiCell always should be located indoors. The GPS antenna detached from the UbiCell must be laid in a horizontal position, as close to a window as possible. Laying it on a window is ideal. To be certain of keeping the antenna horizontal, you may wish to tape it down, but do not use duct tape.

  • Page 18

    5) Connect and secure the GPS antenna to the exposed port by using the GPS cable. 6) Connect and secure the terminal end of the same mini-coax cable to the port on the GPS antenna. _ © SAMSUNG Electronics Co., Ltd.

  • Page 19: Registering Your Ubicell

    Registering your UbiCell Before installing your UbiCell you need to register. Registering Your UbiCell will not be able to function if the instruction is violated. Your UbiCell should be registered first. UbiCell User Guide _...

  • Page 20: Overview

    OVERVIEW The UbiCell is a system that performs the radio interface with Mobile Stations (MS), and exchanges radio subscriber data and signal data with the MSs under CDMA2000 standards. Home or Office Provider’s Network Security Gateway UbiCell _ © SAMSUNG Electronics Co., Ltd.

  • Page 21

    INSTALLING YOUR UBICELL If possible, place the UbiCell in a high location such as on top of a book shelf or tall cabinet. For best results place the UbiCell in a room with a window. Make sure your DSL modem or cable modem and broadband router are on and working properly.

  • Page 22

    1) Connect one end of the included Ethernet cable to an open port on the modem. 2) Connect the other end to the WAN port located at the rear of the UbiCell. 3) Plug the power supply connector into the PWR connector located at the rear of the UbiCell. _ © SAMSUNG Electronics Co., Ltd.

  • Page 23

    2) Ethernet cable connector (RJ-45) should be plugged before plugging a DC power cable. Connecting the power 1) Please use a refined accessory and a charger provided or activated by Samsung Electronics. 2) Use only the power supply and cord that are included in the package.

  • Page 24

    Checking the LED The ‘PWR’ LED on the front of the UbiCell should lit up blue when power is connected normally. Over the next few minutes the ‘WAN’ LED, the ‘GPS’ LED, and the ‘SYS’ LED should all lit up blue. (If after 10 minutes any of the LEDs is not lit up, or is lit up red, see the ‘Troubleshooting’...

  • Page 25: Troubleshooting

    Ethernet connection. - Confirm that both ends of the Ethernet cable are securely plugged into the WAN port on the UbiCell and into an open port on the router(or modem). UbiCell User Guide _...

  • Page 26

    - If the preceding fails, remove the power cord from the wall outlet, and then remove the power supply connector from PWR connector at the rear of the UbiCell for at least 10 seconds. - Reconnect the power supply connector to the PWR connector, plug the power cord into the wall outlet.

  • Page 27: Product Specifications

    ANNEX A Product Specifications The specifications of the UbiCell are as follows: Capacity The capacity of the UbiCell is described as follows: Category Specification Maximum Number of Frequencies 1 FA Sector Omni Maximum Number of Channels 4 CEs UbiCell User Guide _...

  • Page 28

    Transmitter/Receiver Specification The specification of the transmitter and receiver of the UbiCell is described as follows: The items that are not included in the following table should meet the IS-95A/B, IS-2000 standard. Item Specification Transmission Tx Frequency 1,930~1,990 MHz or 869~894 MHz Channel Bandwidth 1.25 MHz...

  • Page 29

    144.0 ×204.4 × 42.2 Weight (g) 955 (580+ 375[adapter & cables]) ± 40 Power The specification of the UbiCell power is described as follows. The UbiCell meets the power safety criterion defined in UL60950-1 and EN60950-1. Category Specification Input Voltage AC 110 V...

This manual also for:

Scs-26uc4

Comments to this Manuals

Symbols: 0
Latest comments: