Toyota Sienna 2010 Owner's Manual page 403

Programming a Rolling Code system (for U.S.A. owners)
■
If your device is Rolling Code equipped, follow the steps under the
heading "Programming the HomeLink
the steps listed below.
Locate the training button on the ceiling mounted garage door
STEP 1
opener motor. The exact location and color of the button may
vary by brand of garage door opener.
Refer to the operation manual supplied with the garage door opener
for the location of the training button.
Press the training button.
STEP 2
Press and release the vehicle's programmed HomeLink
STEP 3
ton twice. The garage door may open.
If the garage door opens, the programming process is complete. If
the door does not open, press and release the button a third time.
This third press and release will complete the programming process
by opening the garage door.
The ceiling mounted garage door opener motor should now recog-
nize the HomeLink
Repeat the steps above to program another rolling code sys-
STEP 4
tem for any of the remaining HomeLink
Programming an entry gate (for U.S.A. owners)/Programming
■
all devices in the Canadian market
Place your transmitter 1 to 3 in. (25 to 75 mm) away from the
STEP 1
surface of the HomeLink
Keep the indicator light on the HomeLink
ming.
Press and hold the selected HomeLink
STEP 2
Repeatedly press and release (cycle) the device's remote
STEP 3
control button for two seconds each until step 4 is complete.
When the indicator light on the HomeLink
STEP 4
ceiver starts to flashing rapidly, release the buttons.
®
transceiver and operate the garage door.
®
.
3-7. Other interior features
®
" before proceeding with
®
buttons.
®
in view while program-
®
button.
®
compatible trans-
®
but-
3
407