Activate The Answering System; Set The Clock - VTech LS6125 User Manual

A nsw ering system
A ctiv ate th e answ ering system
The answering system must be turned on to answer and record messages. Press
• If you have caller
A N S O N /O FF to turn the answering system on or off. If the answering system is
ID service, the
turned on, it will announce "C a lls w ill b e a n s w e re d ," and the A N S O N /O FF light
clock will be set
will be on. If the answering system is turned off, it will announce "C a lls w ill n o t
automatically with
incoming calls, b e a n s w e re d ," and the A N S O N /O FF light will be off.
but you will need
S et th e clock
to make sure the
year is correct.
Prior to playing a message, the answering system announces when it was
See S et th e clock
for instructions received. Before using the answering system, set the year, time and day, so that
on how to set the
messages are dated correctly. If the clock is not set before new messages are
year, time and day
recorded, the system will announce "T im e a n d d a y n o t s e t," before each message
manually.
is played to remind you to set the clock.
• Press and hold
Press CLO CK . The system announces the clock setting (e.g. year, time and
/S K IP or 1.
/R E P E A T while
day), then announces: "T o s e t th e c lo c k , p re s s CLOCK."
setting the minutes
Press CLO CK . The system announces the current year.
2.
or year to advance
Press /S K IP or /R E P E A T until the system announces the correct year, then
or decrease by 3.
increments of ten. press CLO CK . The system announces the current hour.
Press /S K IP or /R E P E A T until the system announces the correct hour, then
4.
press CLO CK . The system announces the current minute.
Press /S K IP or /R E P E A T until the system announces the correct minute,
5.
then press CLO CK . The system announces the current day.
28
w w w .v tech ph ones.com