Set Telephone Base Ringer; Set Remote Access Code - VTech LS6125 User Manual

A nsw ering system
S et teleph one b ase ringer
This feature allows you to select the telephone base ringer volume level. You
can choose from H I (high), O F (off) or LO (low).
Press S E T U P when the phone is not in use, until the system announces the
1.
telephone base ringer setting.
Press /S K IP or /R E P E A T until the system announces the desired telephone
2.
base ringer volume level, then press S E T U P to save the setting and go to the
next setting, or press
S et remote access cod e
A two-digit security code is required to access the answering system remotely
from any touch tone telephone. The preset code is 19. You can set the code
from 10 to 99.
To set the remote access code:
Press S E T U P when the phone is not in use, until the system announces the
1.
remote access code setting.
Press /S K IP or /R E P E A T to change the remote access code by one, or
2.
press and hold /S K IP or /R E P E A T to change it by increments of ten. Press
S E T U P to save the setting and go to the next setting, or press
to save and exit set up mode.
30
/P LA Y /S T O P to save and exit set up mode.
w w w .v tech ph ones.com
/P LA Y /S T O P