Change The System Pin Code; Set The Direct Memory Keys; Registration - VTech DS6177A User Manual

7.9

Change the System pIN Code

1. Press OK / MENU and then
2. Press OK / MENU and then
3. Press OK / MENU and you are requested to enter the 4-digit system PIN.
4. Enter the old system PIN.
5. Press OK / MENU and the screen will display "NEW pIN", then enter the new
system PIN code.
6. Press OK / MENU and the screen will display "rEpEAT", then enter the new
system PIN code again.
7. Press OK / MENU to confirm.
7.10

Set the Direct Memory Keys

There are five direct memory keys(
these direct memory keys and dial them directly from idle mode.
1. In idle mode, enter the number you want to store.
2. Press and hold any direct memory key until you hear a confirmation tone that
indicates the number is stored in that key.
3. Press any direct memory key to dial the number stored in that key.
7.11

registration

Your headset and base station is pre-registered. Up to four handsets or headsets can
be registered to a single base.
If you registered the headset to other telephone base, the headset will cancel the
registration to the current telephone base automatically.
If for some reason, the headset is not registered to the base station, register your
headset according to the following procedure.
1. Press OK / MENU and then
2. Press OK / MENU and the screen will display "pLEASE WAIT".
3. At the same time, press and hold + and - on the headset for about five seconds,
the base station is entered into registration mode. The red and blue light flash
alternately to show that the registration is in progress.
4. For a short delay, you will hear a confirmation tone if the registration is successful.
Note
Press TALK ON/ TALK OFF on the headset at any time to exit the registration process.
If the registration is failed, please repeat the steps 1 to 4 above.
/ to select SETTINGS .
/ to select CHANGE pIN .
to ) in you phone. You can store 5 numbers into
/ to select rEGISTrATION.