4079-00X
Carriage Shaft, Belt, And Ink Supply Removals
It is normally not necessary to remove the carriage except to replace
the carriage belt, or to replace the carriage and ink supply assembly.
Warning: If possible, move the printer to a suitable service area,
and cover the table with the drop cloth before servicing ink
tubes or the purge unit.
1. Remove the covers.
2. Center the carriage (see
Centering" on page
3. Remove the operator panel and base.
4. Remove the print timing slit from the carriage.
5. Disconnect the carriage cables (1) and the carriage motor cable
(2).
4-23
"Printhead Uncapping and Carriage
4-9.