Table of Contents
Advertisement
4079-00X
Lower Frame Removal
If it is necessary to remove the white ribbon cables or the motor
cables, follow this procedure. Make sure the following parts are
removed: Operator panel, operator panel base, controller board,
power supply.
1. Remove the covers.
2. Remove the operator panel and base.
3. Remove the controller card.
4. Remove the power supply.
5. Disconnect the motor cables, system cables, and logic board
cables
.
6. Remove the two screws holding the lower frame in place.
7. Tilt the frame up in the rear, move it back slightly.
8. Lift the frame off the base plate.
4-35
Advertisement
Table of Contents
