4079-00X
26. Purge unit suctions ink from printheads and pumps ink out
through waste ink lines.
27. Head capping mechanism is lowered, allowing the carriage to
return to normal position.
28. Purge motor stops running.
29. Carriage moves about one-fourth of the way to the right.
30. Carriage returns to far left position.
31. Head wiper lowers; purge motor stops running.
32. One short beep is heard. This beep may be very faint when the
controller board is installed.
NOTE: After the printer sits idle for approximately 15 seconds, the
heads are automatically capped and a star (*) appears in the display.
Do not turn off the printer for long periods of time until the heads are
capped and the star (*) appears in the display.
Diagnostic Aids
3-8