Table of Contents
Advertisement
4079-00X
Follow this procedure to adjust the head gap:
1. Center the carriage (see
Centering" on page
2. Unplug the power cord from the AC outlet.
3. Remove the paper guide, top cover, and inner cover.
4. Set the printhead position lever to position 1 (normal position).
5. Using a flat-blade screwdriver, turn the head gap adjustment
(on the left side of the carriage) clockwise until the right-most
click is reached. The head gap is minimum at this position.
6. Move the carriage to the left (home) position.
7. Remove feeler gauges from the feeler gauge set to make a
thickness of 1.7 mm (0.066 in.).
4-3
"Printhead Uncapping and Carriage
4-9.
Advertisement
Table of Contents
