Disassembling The Guards - Technogym Bike MED Service Maintenance Manual

7.7.

DISASSEMBLING THE GUARDS

Figure 7.7-1
Figure 7.7-2
Figure 7.7-3
Page 7.8
BIKE MED: Service & Maintenance Manual - rev. 1.0
1. Back off the 6 screws a on either side of the
machine using a 4-mm Hex wrench.
2. Remove the right guard first, pushing the
pedal back as shown in the figure, and then
removing the guard as indicated by the
arrows.
3. Remove the rubber footrest b.
4. Remove the six pins c from the left guard.
5. Push the left pedal back and remove the left
guard in the same way as the right guard.
To reassemble the guards, carry out the above
steps in reverse order.
During reassembly, lock down the
screws using a torque wrench set for 0.8
Nm.