Table of Contents
Advertisement
Control specifications
1.
Key and switch
BZ
: When an alarm LED is flashing and the buzzer sounds,
Buzzer and remote alarm output are forcibly turned off.
When an alarm lamp flashing and the buzzer does not sound, buzzer remains OFF.
SET
:
Press this key once to enter the device into internal temperature setting mode.
Press the key twice to enter the device into CO
Press the key 3 times to enter the device into O
Press the key 4 times to check over-heat protection temperature.
Press the key 5 times to revert to internal temperature (PV) display.
:
In the setting mode, the device can be shifted the 2
st
1
decimal place.
In PV display, press this key for 5 seconds or more to be Key Lock mode operative.
("L0" is displayed)
:
In the setting mode, the blinking digit counts up.
CAL
:
In PV display, press the key approximately 5 seconds to enter the device into the
internal temperature calibration mode, press again to enter the device into the CO
calibration mode and press again to enter the device into the O
When the CO
instead of the CO
goes into PV display instead of the O
In the temperature calibration mode, input FXX with
key to enter the device into the function mode to obtain information of each mode.
Note)
During CO
the CO
continuously even if ENT key is pressed.
ENT
:
During setting mode, CAL mode and Function mode, press the key to store the
value. The function is not valid for the unchangeable values.
CO
gas
supply
2
line indicator
O
/N
gas supply
2
2
line indicator
setting value (SV) is 0%, the device goes into O
2
calibration mode. When the O
2
/O
Auto Zero adjustment (the decimal point of indicator is flashing),
2
2
/ O
calibration will not be performed with beeping the buzzer for a second
2
2
The key is available only in Auto Changer mode (optional mode) in F08.
:
In Auto Changer mode, press the key to switch the cylinder in use to
another one. When lamp lighting indicates as the CO
current use. When blinking indicates as the CO
Lamp is turned off if Auto Changer mode is unavailable in F08.
Press the key to switch the cylinder emptied to another one. (That is Auto
:
Changer mode).
(Ex: When the O
switches to blink.
level setting mode.
2
level setting mode.
2
is set at 18.1~21.9%, the device
2
calibration mode.
2
/N
cylinder in current used is emptied, the lamp
2
2
10
nd
st
digit
the 1
digit
calibration mode.
2
calibration mode,
2
key and then press ENT
cylinder A in
2
cylinder B in current use.
2
the
2
Hide quick links:
Advertisement
Table of Contents
