Enabling Dns - Avaya S8500 User Manual

Using the Avaya Remote Supervisor Adapter
Alerts
4
Host Name or IP Address [no default]: In the field that corresponds with the Community Name,
type the IP Address or Host Name for each community manager.
5
If a DNS server is not used or available, scroll down and click Save. If a DNS server will be used,
continue to
NOTE:
You must restart the ASM to activate the Network Protocols changes.
6
To restart the ASM, click Restart ASM under the ASM Control heading in the navagation pane.

Enabling DNS

To enable the Domain Name System (DNS) and specify the DNS IP address:
1
In the navigation pane, select Network Protocols under the ASM Control heading.
The Simple Network Management Protocol (SNMP) window appears.
2
Scroll down to the DNS section (see
Figure 21: DNS
3
In the DNS field [default: Disabled]: Select Enabled from the drop-down menu if a DNS server
will be used.
4
In the DNS server IP address 1, 2, and 3 fields [default: 0.0.0.0]: You can specify up to three
DNS server IP addresses once the DNS field is Enabled. Each IP address should contain integers
0 through 255, separated by periods.
5
Scroll to the bottom of the page and click Save.
NOTE:
You must restart the ASM to activate the Network Protocols changes.
6
To restart the ASM, select Restart ASM under the ASM Control heading in the navigation pane.
46
Enabling DNS on page 46 before restarting the ASM.
Figure 18, Advanced Ethernet setup,
Avaya Remote Supervisor Adapter User Guide
on page 43).
November 2003