Stopping The Machine; Adjusting The Height Of Cut; Adjusting The Anti-Scalp Rollers - Toro TimeCutter Operator's Manual

Tow
This is the medium speed. The suggested uses for
this speed are as follows:
•
Bagging
•
Mulching
Mow
This is the fastest speed. The suggested uses for this
speed are as follows:
•
Normal mowing
•
Transporting the machine

Stopping the Machine

To stop the machine, move the motion-control
levers to N and outward to the P
EUTRAL
disengage the blade-control switch, ensure that the
throttle is in the F position, and turn the ignition
AST
key to O . Remove the key from the ignition switch.
FF
WARNING
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and move
the motion-control levers outward to the
P position when leaving the machine
ARK
unattended, even if just for a few minutes.

Adjusting the Height of Cut

Note:
The transport position is the highest
height-of-cut position at 115 mm (4-1/2 inches) as
shown in Figure 23.
position,
ARK
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
do not touch the ground in normal, flat mowing areas.
1.
2.
3.
21
Figure 23
Adjust the anti-scalp rollers so that the rollers
Disengage the blade-control switch (PTO), move
the motion-control levers to the P
and engage the parking brake.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Adjust the anti-scalp rollers as shown in
24 to match the closest height-of-cut position.
g027504
position,
ARK
Figure