Toro TimeCutter Operator's Manual page 37

1. Cutting edge
2. Curved area
Checking for Bent Blades
Note:
The machine must be on a level surface for
the following procedure.
1. Raise the mower deck to the highest
height-of-cut position.
2. While wearing thickly padded gloves, or other
adequate hand protection, slowly rotate the
blade to be measure into a position that allows
effective measurement of the distance between
the cutting edge and the level surface the
machine is on (Figure
1. Deck
2. Spindle housing
3. Measure from the tip of the blade to the flat
surface (Figure 48).
Figure 46
3. Wear/slot forming
4. Crack
47).
Figure 47
3. Blade
g006530
1. Blade (in position for measuring)
2. Level surface
3. Measured distance between blade and the surface (A)
4. Rotate the same blade 180 degrees so that
the opposing cutting edge is now in the same
position (Figure
1. Blade (side previously measured)
2. Measurement (position used previously)
3. Opposing side of blade being moved into measurement
position
g014972
5. Measure from the tip of the blade to the flat
surface (Figure
Note:
The variance should be no more than
3 mm (1/8 inch).
37
Figure 48
49).
Figure 49
50).
g014973
g014974