Installing The Mower; Replacing The Grass Deflector - Toro TimeCutter Operator's Manual

Figure 58
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to
the ground.
6. Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground (Figure
Figure 59
1. Mower deck
2. Hanger bracket
7. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
3. Deck bracket
59).
3. Rear lift rod
8. Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.

Installing the Mower

1. Park the machine on a level surface and
disengage the blade-control switch.
2. Move the motion-control levers outward to the
P position, shut off the engine, remove the
ARK
key, and wait for all moving parts to stop before
leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest
position.
5. Lift the rear of the mower deck and guide the
hanger brackets over the rear lift rod
6. Attach the front support rod to the mower deck
g014635
with the clevis pin and hairpin cotter
7. Install the mower belt onto the engine pulley;
refer to Replacing the Mower Belt (page
Replacing the Grass
Deflector
Inspect the grass deflector for damage before each
use. Replace any damaged parts before use.
1. Disengage the spring from the notch in the
deflector bracket and slide the rod out of the
welded deck brackets, spring, and discharge
deflector
g005077
41
(Figure 60).
(Figure 59).
(Figure 58).
43).