Toro TimeCutter Operator's Manual page 20

Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion-control
levers rearward (Figure
Figure 21
Using the Smart Speed
System
The Smart Speed TM Control-System lever, located
below the operating position
operator a choice to drive the machine at 3 ground
speed ranges—trim, tow, and mow.
Figure 22
1. Smart-speed lever
To change speeds, do the following:
1. Move the motion-control levers to neutral and
outward to the P
ARK
2. Disengage the blade-control switch.
21).
TM Control
(Figure 22), gives the
position.
3. Adjust the lever to the desired position.
The following are only recommendations for use.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Suggested Trim
uses:
Parking X
Heavy, wet X
grass
Training X
Bagging
Mulching
Normal
mowing
Transport
Trim
This is the lowest speed. The suggested uses for this
speed are as follows:
•
Parking
g008953
•
Heavy, wet grass mowing conditions
•
Training
g027625
20
Tow Mow
X
X
X
X