Toro TimeCutter Operator's Manual page 30

Changing the Engine Oil and the
Engine-Oil Filter
Service Interval: Every 100 hours—Change the
engine oil and the engine-oil filter.
Note:
The drain plug is attached to the drain hose.
Note:
Dispose the used oil at a recycling center.
Fill with oil as specified in the table as shown in
32.
1. Park the machine so that the drain side is slightly
lower than the opposite side to ensure that the
oil drains completely.
2. Disengage the blade-control switch and move
the motion-control levers outward to the P
position.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Figure 34
4. Torque the plug to 14 N∙m (125 in-lb).
Figure
ARK
5. Slowly pour approximately 80% of the specified
oil into the filler tube
g027934
30
Figure 35
(Figure 36).
g027477