Toro TimeCutter Operator's Manual page 42

Figure 60
1. Rod
2. Spring
3. Deflector
2. Remove the damaged or worn discharge
deflector.
3. Position the new discharge deflector with the
bracket ends between the welded brackets on
the deck as shown in
4. Install the spring onto the straight end of the rod.
5. Position the spring on the rod as shown in
60 so that the shorter spring end is coming from
under the rod before the bend and going over
the rod as it returns from the bend.
6. Lift the loop end of the spring and place it into
the notch on the deflector bracket
4. Deck brackets
5. Spring installed over the
rod
Figure 61.
Figure
(Figure 61).
1. Rod and spring assembly
installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
7. Secure the rod and spring assembly by twisting
it so the short end of the rod is placed behind
the front bracket welded to the deck
g017617
Important:
spring loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
42
Figure 61
3. Rod, short end, moved
behind mower bracket
4. Short end, retained by
mower bracket.
The grass deflector must be
g017618
(Figure 61).