Table of Contents
Advertisement
24
AutoGRAPH-ST
•
USER MANUAL
Connection to PC
For configuration it is necessary to connect the AutoGRAPH-ST to a PC.
For correct operation it is required to install the AutoGRAPH-ST driver before
connection to the PC. For more information on driver installation see the
«Drivers installation» section of the User Manual.
To connect the device to a PC:
• Unscrew the four fastening screws and remove the back cover of the
device.
• Use USB AM – USB microB 5pin data cable to connect the device to a PC.
• Connect the data cable to micro USB connector on the front side of the
PCB.
• Connect the other end of the cable to the PC.
• If the device drivers have been installed previously, the system will
automatically identify the connected device.
• Run the configuration program.
TechnoKom © 2015
Advertisement
Table of Contents
