Table of Contents
Advertisement
12
Inserting the battery
The AutoGRAPH-ST comes with a non-rechargeable Li /SOCI2 battery with a
life time of up to 2 years.
To insert the battery:
• Insert the battery into a pocket in the case intended for battery installation.
• There is a connector on a front side of the PCB intended for connection of
the battery. Plug a male connector from the battery to the connector on the
PCB. Both connectors are keyed to prevent wrong orientation.
• After connection, the battery Power LED will turn on and the device will
start operation. In normal operating mode, the red LED will flash once every 2
seconds. Detailed information about LED operation is given in the «Indication
of Operation» chapter.
• Route the battery cable accurately in the case to stop pinching of cables.
It is not recommended to make tight bends in the cable.
Before installation, check the battery for any damage. Do not use expired batteries. Use only
IMPORTANT
approved batteries. Do not connect incompatible products.
TechnoKom © 2015
AutoGRAPH-ST
•
USER MANUAL
Advertisement
Table of Contents
