Table of Contents
Advertisement
AutoGRAPH-ST
•
Getting Started
Installation of a SIM card
• Unscrew the four fastening screws and remove the back cover of the
device.
• The SIM holder is located on the rear of the PCB.
• Insert a SIM card in the slot with the card's contacts facing the PCB. Be
sure that the card's keying matches the key on the PCB.
• After the installation insert the PCB into the case. Incorrect installation of
the PCB into the case can cause incorrect operation of GNSS receiver. To
prevent this, the case and the PCB are keyed: there is a boss in the case and
there is a mating cut on the PCB.
Do a test of a new SIM card in a cell phone before you install it into the device. Do the test to make
sure that GPRS / SMS / USSD services are enabled and operate properly, the PIN code matches the
IMPORTANT
code pre-set in the device (in order to prevent locking), and a personal account associated with
the SIM card has the sufficient balance for successful operation of the services.
USER MANUAL
11
TechnoKom © 2015
Advertisement
Table of Contents
