Positioning The Soundome; 5.0 Ram Hoist Motor Wiring - Wesmar HD800/45-14 Installation & Operation Manual

4.0 POSITIONING THE
SOUNDOME
To determine how high or low to position the soundome
within the seachest, go below the boat and measure
the distance between the bottom of the soundome and
the bottom of the keel.
The correct position of the soundome boot is for the
bottom to be 23 cm (9 inches) below the keel. See
Page 55, #4. (Remember, the Ram Hoist is shipped in
the down position.)
If the soundome is too high or too low, go back to the
soundome tube.
Loosen the top hoist clamp and the safety clamp.
Raise or lower the soundome according to your mea-
surement.
Align the soundome so that the mark you made on the
tube points aft.
After positioning the soundome tube, tighten the top
hoist clamp and the safety clamp.
Verify the soundome is 23 cm (9 inches) below the keel.

5.0 RAM HOIST MOTOR WIRING

Route the hoist motor wires through one of the small
strain reliefs in the bottom of the junction box. Connect
the numbered lugs of the hoist motor to the same num-
bered terminals on the hoist board in the junction box.
6.0 JUNCTION BOX
INSTALLATION
1. The junction box contains the hoist control board
and the transmitter/receiver board. Select a convenient
location close to the hoist assembly that can be reached
by the soundome cable.
Do not extend the length of the soundome cable as it
may introduce noise and shorten range performance.
Page 58
HD800
Note: Use Anti-seize on all stainless steel
bolts and nuts before tightening. This
will reduce the affect of galling or seizure.
RAM HOIST
WESMAR