Debug Settings - TECOM GW5051 User Manual

DIRECT ACCESS to GW5051
OnHook Regret Timeout, On hook regret function allows you continue your call after
you hang up the phone. You have a regret timeout to pick up the phone again and
continue your call. This works only in case of incoming call.
Call failure RTP Timeout, active call failure treatment by RTP timeout and call
resources disconnection.
DSCP for SIP and DSCP for RTP, options, these two parameters are used for QoS
setting,
Configure difference DSCP value for SIP or RTP transport if you are familiar with the
service, otherwise voice quality may be affected abnormally.
DTMF relay, it allows you to set the way how the DTMF is transmitted during voice
call. Generally, DTMF digit can be passed via in-band or RFC2833 (out of band).
SIP-INFO option is not suggested unless the service provider permitted.
HOOK Flash Relay Setting, which is used to configure the way how the hook flash is
transmitted. Generally it is not need, so the default value is None.
SIP Transport Protocol, GW5051 both support UDP and TCP to transport SIP signal.
Polarity Reversal, payphone supporting. If you use GW5051 with a payphone,
please enable this option.
Ingress gain and Egress gain support, it allows you to configure different level for
each line.

3.12.6. Debug Settings

Figure 3-8-7 Debug Settings of voice function
Debug settings allows you to record the voice log, you only need to configure the log
server information, which includes IP address and port.
The voice console log level support three log levels, which are
Error, Notice, Debug.
Under Error level setting, error logs will be recorded in log server if errors take place,
Page 38