Table of Contents
Advertisement
II. Panel Description
tactile barrier
1. Transformer Jaw
To measure DC/AC current, enclose the conductor by the jaw.
2. Transformer Trigger
Push the trigger to open the jaw.
3. Zero Button
Push the zero button to zero the output voltage before measuring any current.
4. On/Off and Range Selection Switch
Turn the rotary switch to select the desired range.
5. Power-on LED
When the unit is turned on, this LED will be lighted.
6. Low Battery LED
When the battery voltage is lower than the required voltage, this LED will be lighted
while the power-on LED will be off.
7. Output Terminals
The output voltage is proportional to the current measured. Black terminal is the
signal ground while red terminal is the signal. Do not input any live voltage to
these terminals.
8. Hand Strap
Put your hand through the hole of the hand strap to avoid accidental drop of the
clamp meter.
4
www.tmatlantic.com
Advertisement
Table of Contents
