Talking To Two Parties Alternately (Call Splitting); Making A Three-Party Conference - Panasonic KX-HDV130 Operating Instructions Manual

3.4.4 Talking to Two Parties Alternately (Call Splitting)

3.4.4 Talking to Two Parties Alternately (Call Splitting)
When talking to one party while the other party is on hold, you can swap the calls back and forth
(alternately).
To alternate between the parties leaving one party on hold temporarily (For
KX-HDV130)
1.
Press /
2.
Dial the other party's extension number, and then press /
3.
After talking to the other party, press
4.
Talk to the original party.
To alternate between the parties leaving one party on hold temporarily (For
KX-HDV230)
1.
Press / /
HOLD
2.
Dial the other party's extension number, and then press /
3.
After talking to the other party, press
4.
Press [▲] or [▼] to select the original party, and then press
5.
Talk to the original party.

3.4.5 Making a Three-party Conference

During a conversation, you can add an additional party to your call and establish a conference call.
Note
•
Your phone system may support advanced conference features, such as conference calls with four or
more parties. In this case, the procedures for handling a conference call may be different from those
explained in this section. For details, contact your phone system dealer/service provider.
Making a Conference Call
1.
Press / CONF
2.
Dial the party you want to add to the conversation, and then press
3.
Press / CONF
Removing a Party from the Conference (For KX-HDV130)
During a conference, you can remove other parties from the conference. However, this operation is
available only during conference calls you initiate.
Note
•
To reestablish the conference without removing either party, press
hook or off-hook.
1.
During a conference call, press
2.
Press the corresponding key (
56 Operating Instructions
/ during a conversation.
HOLD/MESSAGE
during a conversation.
Line
during a conversation.
.
/
/ LINE 1/P1
ENTER
/ /
HOLD/MESSAGE
ENTER
.
OK
/ .
HOLD/MESSAGE
or / LINE 2/P2 ) for the party you want to disconnect
.
.
.
.
.
Call
/ CONF after step 2 whether on-
Document Version: 2017-08
.
*1