Holding In A System Parking Zone (Call Park) - Panasonic KX-HDV130 Operating Instructions Manual

Note
•
When a call is received while another call is on hold, pressing and releasing the hook switch will
answer the call.
•
If /
LINE 1/P1
you can retrieve the call on hold by following the step below.
1.
Press the corresponding
To retrieve a call on hold at your line (For KX-HDV230)
1.
Press / /
HOLD
2.
When two or more lines are on hold, press [▲] or [▼] to select a line on hold, and then press
Note
•
When a call is received while another call is on hold, pressing and releasing the hook switch will
answer the call.
•
If a function key is assigned as a Line key, and a call is on hold on that line, you can retrieve the call
on hold by following the step below.
1.
Press the corresponding function key.

3.4.3 Holding in a System Parking Zone (Call Park)

You can use this feature as a transferring feature.
When Call Park is permitted, the
set beforehand. Also, depending on your phone system, you may need to enter a parking zone number to
retrieve a parked call. The feature depends on your phone system. Contact your administrator for further
information.
To set
1.
Press key during a conversation.
Park
Or press an unused (LED is off) function key to which the Call Park function is assigned (KX-HDV230
only).
2.
Go on-hook or press
To retrieve (Call Park Retrieve)
1.
In standby mode, enter the Call Park Retrieve feature number.
Or press a function key in use (blue LED is slowly flashing, or red LED is slowly flashing) to which the
Call Park function is assigned (KX-HDV230 only).
2.
Go off-hook.
Note
•
Depending on the telephone system, the
call. In this case, you can retrieve the call by pressing the blinking
a parked call using the soft key, the Call Park Retrieve feature number must be set beforehand.
Contact your administrator for further information.
Document Version: 2017-08
or / key is assigned as a Line key, and a call is on hold on that line,
LINE 2/P2
/
LINE 1/P1
.
soft key is displayed. However, the Call Park feature number must be
Park
.
OK
3.4.3 Holding in a System Parking Zone (Call Park)
or /
LINE 2/P2
soft key might blink to show that the line has a parked
Park
key.
soft key. However, to retrieve
Park
Operating Instructions
.
OK
55