HP A7500 Series Configuration Manual page 197

[SwitchA-GigabitEthernet1/0/3] undo stp enable
[SwitchA-GigabitEthernet1/0/3] undo lldp enable
[SwitchA-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchA-GigabitEthernet1/0/3] quit
# Create a tunnel interface Tunnel 1.
[SwitchA] interface tunnel 1
# Configure an IPv4 address for interface Tunnel 1.
[SwitchA-Tunnel1] ip address 10.1.2.1 255.255.255.0
# Configure the tunnel encapsulation mode as GRE over IPv4.
[SwitchA-Tunnel1] tunnel-protocol gre
# Configure the source address of interface Tunnel 1 to be the IP address of the VLAN interface of
interface GigabitEthernet 1/0/2.
[SwitchA-Tunnel1] source vlan-interface 101
# Configure the destination address for interface Tunnel 1 (IP address of the VLAN interface to which
GigabitEthernet 1/0/2 of Switch B belongs).
[SwitchA-Tunnel1] destination 2.2.2.2
# Apply service loopback group 1 to the tunnel in tunnel interface view.
[SwitchA-Tunnel1] service-loopback-group 1
[SwitchA-Tunnel1] quit
# Configure a static route from Switch A through interface Tunnel 1 to Group 2.
[SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 1
Configure Switch B
2.
# Configure an IPv4 address for interface GigabitEthernet 1/0/1.
<SwitchB> system-view
[SwitchB] vlan 100
[SwitchB-vlan100] port GigabitEthernet 1/0/1
[SwitchB-vlan100] quit
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ip address 10.1.3.1 255.255.255.0
[SwitchB-Vlan-interface100] quit
# Configure an IPv4 address for interface GigabitEthernet 1/0/2, the physical interface of the tunnel.
[SwitchB] vlan 101
[SwitchB-vlan101] port GigabitEthernet 1/0/2
[SwitchB-vlan101] quit
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ip address 2.2.2.2 255.255.255.0
[SwitchB-Vlan-interface101] quit
# Create service loopback group 1, and configure the service type as tunnel.
[SwitchB] service-loopback group 1 type tunnel
# Add port GigabitEthernet 1/0/3 to service loopback group 1, and disable STP and LLDP on the port.
[SwitchB] interface GigabitEthernet 1/0/3
[SwitchB-GigabitEthernet1/0/3] undo stp enable
[SwitchB-GigabitEthernet1/0/3] undo lldp enable
[SwitchB-GigabitEthernet1/0/3] port service-loopback group 1
189