Local Proxy Arp; Enabling Proxy Arp - HP A7500 Series Configuration Manual

Local proxy ARP

As shown in
to GigabitEthernet 1/0/3 while Host B connects to GigabitEthernet 1/0/1. Enable local proxy ARP on
Switch A to allow Layer 3 communication between the two hosts.
Figure 8 Application environment of local proxy ARP
Enable local proxy ARP in each of the following cases:
Hosts connecting to different isolated Layer 2 ports in the same VLAN need to communicate at Layer
•
3.
If a super VLAN is configured, hosts in different sub VLANs of the super VLAN need to communicate
•
at Layer 3.
• If an isolate-user-VLAN is configured, hosts in different secondary VLANs of the isolate-user-VLAN
need to communicate at Layer 3.

Enabling proxy ARP

Follow these steps to enable proxy ARP in VLAN interface view/Layer 3 Ethernet port view/Layer 3
Ethernet subinterface view/Layer 3 aggregate interface view/Layer 3 aggregate subinterface view:
To do...
Enter system view
Enter interface view
Enable proxy ARP
Follow these steps to enable local proxy ARP in VLAN interface view/Layer 3 Ethernet port view/Layer
3 Ethernet subinterface view/Layer 3 aggregate interface view/Layer 3 aggregate subinterface view:
To do...
Enter system view
Enter interface view
Figure 8, Host A and Host B belong to VLAN 2, but are isolated at Layer 2. Host A connects
Use the command...
system-view
interface interface-type
interface-number
proxy-arp enable
Use the command...
system-view
interface interface-type
interface-number
16
Remarks
—
—
Required
Disabled by default.
Remarks
—
—