Configuring A 6To4 Tunnel; Configuration Prerequisites; Configuration Guidelines - HP A7500 Series Configuration Manual

3001::2, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF00:1
FF02::1:FFA8:3201
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives:
...
# Ping the IPv6 address of VLAN-interface 101 at the peer end from Switch A.
[SwitchA] ping ipv6 3003::1
PING 3003::1 : 56
Reply from 3003::1
bytes=56 Sequence=1 hop limit=64
Reply from 3003::1
bytes=56 Sequence=2 hop limit=64
Reply from 3003::1
bytes=56 Sequence=3 hop limit=64
Reply from 3003::1
bytes=56 Sequence=4 hop limit=64
Reply from 3003::1
bytes=56 Sequence=5 hop limit=64
--- 3003::1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/1/1 ms

Configuring a 6to4 tunnel

Configuration prerequisites

Configure IP addresses for interfaces (such as the VLAN interface, and loopback interface) on the device
to ensure normal communication. One of the interfaces will be used as the source interface of the tunnel.

Configuration guidelines

Follow these guidelines when you configure a 6to4 tunnel:
No destination address needs to be configured for a 6to4 tunnel because the destination address
•
can automatically be obtained from the IPv4 address embedded in the 6to4 IPv6 address.
55
data bytes, press CTRL_C to break
time = 1 ms
time = 1 ms
time = 1 ms
time = 1 ms
time = 1 ms
159