FLASHFORGE 3D PRINTER INVENTOR Quick Start Manual page 4

1.Open box and remove bag containing the lid,
Quick start guide, After-sales service card,
levelling card, and two build taps.
3.Firmly grasp the two sides handles of Inventor.
Lift it out from the carton and place it on a
stable surface. Then you will see the Toolbox
and USB cable in the shipping box.
5.Take foam out of the Inventor.
Unpacking
2.Take the power cable and two foam sheets
out from the top.
4.Remove the packing bag.(Tip:Save your
packaging for future transportation and
storage.)
6.Open the box inside the printer. It should
contain: dual extruder, two side panels,
and extruder's accessory kit. Remove dual
extruder and place it on a clean surface.
Note: the extruder cable is short; please do
not leave the extruder hanging by the cable.
03