TechWind SDK-500 User Manual page 32

Register Write
0x0210 No
0x0211 No
0x0212 No
0x0213 No
0x0214 No
0x0215 No
0x0216 No
0x0217 No
0x0218 No
0x0219 No
0x021A No
0x021B No
0x021C No
0x021D No
0x021E No
0x021F No
0x0220 No
0x0221 No
0x0222 No
0x0227 No
0x0228 No
0x0229 No
0x022A No
0x022B No
0x1004 Yes
32
User's manual for
Range
- Door width in pulses, high byte
- Door width in pulses, low byte
200 ÷ 3999 „Width"
10 ÷ 399 „Weight"
0 ÷ 79 „V opening"
0 ÷ 79 „V closing"
50 ÷ 999
„Init. speed "
- Acceleration/deceleration speed of door opening
- Acceleration/deceleration speed of door closing
- Start point of deceleration while opening in [mm]
- Start point of deceleration while closing in [mm]
0 ÷ 299 „Lock zone" parameter in „Calibration" menu, in [mm]
„OPENING inp." parameter in „Inputs" menu:
0 ÷ 1
0 – inactive; 1 - active;
„CLOSING inp." parameter in „Inputs" menu:
0 ÷ 1
0 – inactive; 1 - active;
„OPEN switch" parameter in „Calibration" menu:
0 ÷ 1
0 – inactive; 1 - active;
„OPEN output" parameter in „Outputs" menu:
0 ÷ 2
0 – inactive; 1 - normal open; 2 - normal closed
„CLOSED outp." parameter in „Outputs" menu:
0 ÷ 2
0 – inactive; 1 - normal open; 2 - normal closed
„BARRIER out." parameter in „Outputs" menu:
0 ÷ 2
0 – inactive; 1 - normal open; 2 - normal closed
„External" parameter in „Photocell" menu:
0 ÷ 2
0 – inactive; 1 – transfer; 2 - active
„INSTALL inp." parameter in „Inputs" menu:
0 ÷ 1
0 – inactive; 1 - active;
- Additional input (not used)
„Language" parameter in „Region" menu:
0 ÷ 1
0 – Polish; 1 - English;
„Lock. speed" parameter in „Calibration" menu:
0 ÷ 5
0 – MIN.; 1 – 20% ... 5 – 100%
0 ÷ 99 „Force reduc."
Write only register, allows to door control while RS-485 mode:
see desc.
0 – open, 0x100 – close,
elevator door controller
Register description
parameter in „Doors data" menu, in [mm]
parameter in „Doors data" menu, in [kg]
parameter in „Speeds" menu, in [cm/s]
parameter in „Speeds" menu, in [cm/s]
parameter in „Calibration" menu, in [0.1%]
parameter in
SDK-500
„Calibration" menu, in [%]